Audio-Technica AT-OC9XML

The next Generation of the legendary OC9 cartridge series

Since its introduction more than 30 years ago, Audio-Technica’s pioneering moving coil OC9 cartridge series has been prized by demanding vinyl listeners and professional critics alike for its musical transparency, expression of sound and precise construction. Microlinear complex diamond profile enabling higher frequency response, detail like never before experienced and limiting inner groove distortion. Microlinear diamond profile provides low record and stylus wear.

• Features nude Microlinear stylus and boron cantilever which provides lower distortion and high transient response
• A neodymium magnet and permendur yoke provides dramatically increased magnetic energy
• Threaded inserts in the cartridge body enable the cartridge to be mounted on to the headshell or integral tonearm with just two screws – no nuts required 
• Aluminium body minimizes unwanted vibration for reduced resonance and a superior audio reproduction
• Pure Copper by Ohno Continuous Casting process (PCOCC) is used for the coils to achieve pure signal transfer

Befestigung 1/2” centers / Threaded

Frequenzbereich 20 - 47,000 Hz

Material d. Gehäuses Aluminium

Kanaltrennung 27 dB (1 kHz)

Kanalbalance am Ausgang 1.0 dB (1 kHz)

Ausgangsleistung 0.4 mV (at 1 kHz, 5 cm/sec)

Vertikaler Abtastwinkel 20 degrees

Vertikaler Auflagekraftbereich 1.8 to 2.2 g (standard 2.0 g)

Nadelschliff Microlinear

Nadelabmessungen 2.2 x 0.12 mil

Schaftform der Nadel Nude square shank

Nadelträger 0.28 mm Ø nude boron

Spulenimpedanz 12 Ohms (1 kHz)

Spuleninduktivität 25 μH (1 kHz)

DC Widerstand 12 Ohms

Statische Nadelnachgiebigkeit 20 x 10 – 6 cm / dyne

Dynamische Nadelnachgiebigkeit 16 x 10 – 6 cm / dyne (100 Hz)

Anschlusspins Brass

Spulendraht PCOCC (Copper by Ohno Continuous Casting process.)

Empfohlene Lastimpedanz Min 100 Ohms

Gewicht 7.6 g

Abmessungen 17.3 (H) x 16.8 (W) x 25.7 (L) mm

Beiliegendes Zubehör 1 non magnetic screw driver, 1 brush, 2 washers, 4 pairs of mounting screws: 5mm, 8mm, 10mm, 12mm, 1 plastic protector