Audio-Technica AT-OC9XSL

The next Generation of the legendary OC9 cartridge series

Since its introduction more than 30 years ago, Audio-Technica’s pioneering moving coil OC9 cartridge series has been prized by demanding vinyl listeners and professional critics alike for its musical transparency, expression of sound and precise construction. Special Line Contact as featured in our flagship ART1000, this diamond profile offers the ultimate in accurate sonic reproduction with a sense of space and realism to all instruments that few other configuration can achieve.

• Features Nude Special Line Contact stylus and boron cantilever with accurate tracking ability and high transient response
• A neodymium magnet and permendur yoke provides dramatically increased magnetic energy
• Threaded inserts in the cartridge body enable the cartridge to be mounted on to the headshell or integral tonearm with just two screws – no nuts required 
• Aluminium body minimizes unwanted vibration for reduced resonance and a superior audio reproduction
• Pure Copper by Ohno Continuous Casting process (PCOCC) is used for the coils to achieve pure signal transfer 

Befestigung 1/2” centers / Threaded inserts

Frequenzbereich 20 - 50,000 Hz

Material d. Gehäuses Aluminium

Kanaltrennung 28 dB (1 kHz)

Kanalbalance am Ausgang 0.5 dB (1 kHz)

Ausgangsleistung 0.4 mV (@ 1 kHz, 5 cm/sec)

Vertikaler Abtastwinkel 20 degrees

Vertikaler Auflagekraftbereich 1.8 to 2.2 g (standard 2.0 g)

Nadelschliff Special Line Contact

Nadelabmessungen 1.5 x 0.28 mil

Schaftform der Nadel Nude rectangular shank

Nadelträger 0.28 mm Ø nude boron

Spulenimpedanz 12 Ohms (1 kHz)

Spuleninduktivität 25 μH (1 kHz)

DC Widerstand 12 Ohms

Statische Nadelnachgiebigkeit 22 x 10 – 6 cm / dyne

Dynamische Nadelnachgiebigkeit 18 x 10 – 6 cm / dyne (100 Hz)

Anschlusspins Brass

Spulendraht PCOCC (Copper by Ohno Continuous Casting process.)

Empfohlene Lastimpedanz Min 100 Ohms

Gewicht 7.6 g

Abmessungen 17.3 (H) x 16.8 (W) x 25.7 (L) mm

Beiliegendes Zubehör 1 non magnetic screw driver; 1 brush; 2 washers; 4 pairs of mounting screws: 5mm, 8mm, 10mm, 12mm; 1 plastic protector